I have a specific need to flame polish a cellulose acetate rod about 1/8" in dia. at about 300 per minute in
an automatic machine. It does not need much heat, but will require a flame using either natural gas or
propane and appropriate ignition and flame control devises. If you can help with this requirement please
contact us as indicated above.
The Tinman Respondeth:
Our Meco N Midget may be the ticket. It will handle Natgas and "Propain" with the special fuel tips. A
special 7" tip extension, (gooseneck) is available that may be bent to your needs, also. The torch body
is shaped like a little cigarette pack, which may offer convenient clamping geometry for your machine.
The torch is also the most resistant to popping of all on the market today.