Meco Aviator Jet Adaptor
Tip adaptor to save the MECO AVIATOR JET
Victor bought Meco a long time back, but as of Nov. 99 All of the Meco line except for the N Midget
was...destroyed. Many of us distributors wrote and phoned for weeks to save the JET, but alas, could not.
However, if you have one, I think it can be saved. I can adapt the N Midget tip fitting on to the end of a
JET tip thereby enabling the range of Midget tips to be fit to the JET. See photo on right. The N Midget
goes up to a 5 or 6 which is pretty good (check the tip selection charts below).
Send me any one JET tip and I will adapt the end. Call for price.
Standard Meco Tip Sizes, in Wire Drill and Decimal
00
0
1
2
3
4
5
#80
#76
#70
#65
#58
#56
#52
.0135"
.020"
.028"
.035"
.042"
.046"
.063"
Victor Welding Tip Sizes
Tip Size
000
00
0
1
2
3
4
5
6
Drill Size
#75
#70
#65
#60
#56
#53
#49
#43
#36
Decimal
.022"
.028"
.035"
.040"
.046"
.0595"
.073"
.089"
.106"
Harris Torch Welding Tip Operational Chart
Tip Size
0
1
2
3
4
5
6
7
8
9
10
13
Drill Size
75
71
65
58
55
53
51
48
45
43
40
35
"I never cared too much for Harris tips, and after seeing the above I understand why. If I had one I
would drill the 0 to drill #72, and 1 to drill #69 or 68.
I now have Midget tips in the following: and I think I have it about right for aircraft welding (of 4130
structural tubing)
0 drilled to #72
1 as is
1 drilled to #68
2 as is
3 as is"
Phone: 530-292-3506 FAX: 530-292-3533 E-mail: info@tinmantech.com
Copyright 2006 TM Technologies. All rights reserved. Visual design by RGD Graphics. Powered by compressed air.
