 |
Inspiration |
|
|
|
|
|
|
Information |
|
|
|
|
|
|
 |
Home >
Products >
Welding >
Adapters & Fittings >
Quick Connects
|
|
| |
| |
Quick Connects |
|
|
These Quick connects provide fast, reliable connection and and quick disconnection for torches, hoses and regulators. All models are color-coded according to gas service for added safety. (Oxygen – Green, Fuel Gas – Red, Inert Gas – Blue) Oxy Fuel models include an integral reverse flow check valve. All of these quick-connects will fit B-sized welding & cutting equipment.
Features & Specifications
| - |
Brass construction provides long service life. Cycle tests have done over 10,000 operations, indicating a service life of 10 to 12 years of comparable use. |
| - |
Non-interchangeable oxygen and fuel gas connectors prevent accidental gas mixing. |
| - |
Instant closure on reverse flow check valves with total shut off at only 10 oz. of back pressure. |
| - |
Exceed CGA flow specifications – 1100 SCFH flow at 125 PSIG inlet pressure and 800 SCFH at 125 PSIG inlet pressure when 2 additional check valves are used in conjunction with the Quick Connects. |
| - |
Spring Loaded locking mechanism responds to fingertip action and achieves a gas tight connection |
| - |
UL Listed |
| - |
For Inert gas models, demand valve on supply side creates a positive seal when fitting is not connected. |
| - |
Double seal socket connection on second seal provides added safety protection |
| - |
Installation and operating instructions included |
| - |
200 PSIG maximum operating pressure |
|
|
Zoom |
Torch to Hose
These allow you to use the same hose with multiple torches without wearing out the threads on the fittings. Keep in mind these are B-sized fitting so this will make your torch very clunky. But the added built in check valves are a nice safety addition.
|
|
|
Zoom |
Hose to Hose
If you want the convenience of a quick disconnect, but you do not want the clunky torch then you have two options. This option allow you to place the quick connect in between two hoses; these have B-sized threads so adapters may be needed if you have a smaller A-sized hose. Check Valves are built into these as well for added safety.
|
|
|
Zoom |
Regulator to Hose
If you want the convenience of a quick disconnect, but you do not want the clunky torch then you have two options. This option allows you to place the quick connect in between the hose and the regulator; these have B-sized threads so adapters may be needed if you have a smaller A-sized hose or regulator. Check Valves are built into these as well for added safety.
|
|
|
Zoom |
Inert Gas
If you have a MIG or TIG welder and you would like to have a have a quick connect on either your machine or the regulator on your cylinder this si the way to go. Because of no potential for flash back there is no check valves inside of this style quick connect.
|
|
|
|
|
| |
|
|
|
|
