Site Search > 
 
Product Search
 
Contact Us   530-292-3506
HOME | PRODUCTS | ASK AN EXPERT | REQUEST A CATALOG | WHAT'S NEW | GIFT CERTIFICATES | CUSTOMER SERVICE | ACCOUNT LOGIN
 
Home   >   Products   >   Hand Tools   >   Punches & Flares   >   Item  
 
Punch & Bead Set
Zoom
Punch & Bead

16 Gauge Capacity - Made In USA

Item # Description Price Qty
MTB-13-013-B   1" Punch & Bead   $95.00  
MTB-13-014-B   1-1/4" Punch & Bead   $95.00  
MTB-13-015-B   1-1/2" Punch & Bead   $110.00  
MTB-13-016-B   1-3/4" Punch & Bead   $110.00  
MTB-13-017-B   2" Punch & Bead   $120.00  
MTB-13-018-B   2-1/2" Punch & Bead   $120.00  
MTB-13-020-B   3" Punch & Bead   $135.00  
MTB-13-402-B   Punch & Bead Set 1" to 2-1/2"   $580.00  
MTB-13-403-B   Punch & Bead Set 1" to 3"   $710.00  


Punch and Bead tools are great for applications where a rubber grommet or bushing will be used, such as floor pans and fire walls. Used most commonly for automotive, these tools give you a consistent, even hole with perfect bead every time. Sizes range from 1" to 3"; complete sets are available. Very simple to use: just drill a pilot hole on center for where the gauge will be mounted. This hole is for the draw bolt. Set one half of the tool on the back side of the panel with the draw bolt going through the hole. Apply the second half of the tool over the draw bolt on the front of the panel and tighten the bolt. The finished hole is smooth and perfectly round. Anti-friction bearings are included with purchase. If you plan to use a hydraulic or manual bench press, no pilot hole is needed. Just use a center punch to mark your location and use the optional spring-loaded center pin to insure exact placement of the hole. See the "How To" video for a demonstration.

The video below shows the Automotive Punch and Flare tool being used on 16 gauge cold rolled steel with the help of a hydraulic bench press and optional spring loaded center pin. If you are using the tool manually you will need to pre drill a pilot hole on center for where the gauge will be mounted. This hole is for the draw bolt. Set one half of the tool on the back side of the panel with the draw bolt going thru the hole, Apply the second half of the tool over the draw bolt on the front of the panel and tighten the bolt.

Be the first person to write a review on this product.

TM Technologies takes pride in knowing we offer the best products on the market for metal working. In an effort to continue this tradition we are constantly improving our products and our product line. If you have any comments or suggestions about this, or any of our other products, we want to hear from you.


Name*
Location*
Email Address*
Product
Review


 
   
 
 
Help Center
PHONE ORDERS:  530-292-3506  (9-5, M-F, PST)
24-hr FAX ORDERS:  530-292-3533
EMAIL ORDERS:  orders@tinmantech.com
 


TM Technologies, Manufacturers & Producers, Nevada City, CA